Here we go, it is the first version of an CAD created shuttlebay for the Reliant. It does have an area in the center where i can add some lights for the warpcore drive. I also added in the middle at the end a wall to have the impulse lights seperated. There are two doors which stays open to allow a transfer from the left to the right side. In the Bottom are holes missing for the Inbound lights for shuttles.
It gets printed tomorrow…
here we go with the first print out. i do believe my guessing about the correct size is not correct.
Additionally i decided that i need the Full Shuttle Bay and not just the “Entry area”. there is so much more required to present and the space seems to be available. Based on it, I decided that the first step is required to get the exact ground size of the Bay and i did the next printouts to find the exact size…
Mark 2 
Mark 3
- 1 – U.S.S.RELIANT – NCC-1864
- 2 – Shuttle Hangar – U.S.S.Reliant
- 3 – LICHT – POSITIONIERUNG
- 4 – SHUTTLE HANGAR DESIGN – USS RELIANT – MARK I
- 5 – SHUTTLE HANGAR DESIGN – RELIANT – MARK V
Aufrufe: 25